This article explains how to install a THINKWARE Hardwiring Cable and enable Parking Mode.
Note: A standard 12V Car Charger Cable is designed for driving power. It has no ACC signal wire and cannot activate Parking Mode. Use a Hardwiring Cable, an OBD-II Power Cable, or an iVolt battery pack for Parking Mode.
Jump to:
Note: Vehicle wiring varies, so THINKWARE customer support cannot provide in-depth hardwiring installation instructions. We strongly recommend professional installation by a technician who can choose the appropriate setup for your vehicle. Damage to your vehicle or dash cam caused by improper installation is not covered by the manufacturer's warranty.
Enable Parking Mode in the app
Enable Parking Mode for your model before installing the Hardwiring Cable. Installing the cable alone does not activate Parking Mode recording. The app steps below apply to models using THINKWARE DASH CAM LINK. For other models, use the supported app, on-camera settings, or PC Viewer identified in Which THINKWARE Mobile app do I use? and follow your model's Parking Mode instructions.
1. Connect your smartphone to the dash cam using the THINKWARE DASH CAM LINK app.
2. Go to [Dash Cam Settings] > [Record Settings] > [Parking Mode].
3. Enable Parking Mode and choose Motion Detection, Time Lapse, Energy Saving, or RADAR where supported.
Note: Smart Parking Recording is a thermal protection function, not a separate Parking Mode. Select [Disabled] if you do not want Parking Mode.
Install using a Hardwiring Cable
A Hardwiring Cable connects the dash cam to the vehicle fuse box to supply power for Parking Mode.
Required tools: Multimeter or circuit tester, plus a Hardwiring Installation Kit with fuse taps suitable for your vehicle or separately purchased vehicle-compatible fuse taps.
1. Locate the interior fuse box, typically beneath the driver's side dashboard.
2. Test each candidate fuse with ignition ON and OFF. Select an ACC fuse powered only when ignition is ON and a Battery fuse that remains powered in both states.
Note: Check both the wire color and the printed cable label: Red = ACC, Yellow = BATTERY, and Black = GND.
3. Connect the red ACC wire to the ACC fuse slot and the yellow Battery wire to the constant-power fuse slot.
4. Secure the black Ground wire to an unpainted metal bolt or stud on the vehicle frame near the fuse box.
Caution: Use an unpainted metal surface. A coated or painted bolt prevents proper grounding and power delivery.
5. Plug the Hardwiring Cable into the dash cam's DC-IN power port.
6. Turn off the vehicle ignition to check the installation.
7. With the installation complete and Parking Mode enabled, listen for the dash cam’s Parking Mode entry announcement.
If the dash cam does not enter Parking Mode after completing the installation checks, see My dash cam does not enter parking mode.
Need more help?
Contact the support team for your region by email or phone. We’ll respond to your email as quickly as we can.
North America (US/CA)
Email: support@thinkware.com
Phone: 1-844-865-9273
United Kingdom (UK)
Email: support.eu@thinkware.com
Phone: +44 (0) 333-121-0008
Europe (EU)
Email: support@thinkwarestore.com
Phone: +49 69 943 22200
Comments
0 comments
Article is closed for comments.